Go Back

Start Page

Parts Book
Photos & # 

Page Links

Why is the cam tight after I had my motor align bored.--> *Click

I have a clicking sound coming from under the valve covers.--> *Click

I am looking for a mild racing clutch setup.--> *Click

Crankshaft checked for cracks "Poor mans Magna-flux" --> *Click

Why is the distributor rotor  pointed towards #3 cylinder when #1 piston is at TDC-- *Click

Front End Bushings don't fit. What should I do.?--> *Click

Generator Pulley Cheap Pulley is Bent or Bad, what to do? --> *Click

Gas Heater Repair & Links to Information on Heaters --> *Click

How can I clean the carbon from my heat risers.--> *Click

Will not dle, Can't get Motor with Solex Carb to Idle--> *Click

How can I check my lower end without tearing down the motor--> *Click

Modified 1st & 2ed Shift Fork Shift How is it done & Why?--> *Click

Can I put a 12v starter & flywheel on my 40hp motor.--> *Click

Adjusting the Valves on my 40 hp motor. Is it done the same way.?--> *Click

The passenger wheel leans out more at top then the drivers side--> *Click

How to install windshield in my buggy --> *Check

  Go Back

   Victor Comp. Products Inc. **--Vic's--**  Phone 816-650-3535 • 230 S Hudson St., Buckner, Missouri, 64016, US